« previous next »
Pages: [1]

Author Topic: Horn sliver in nock question  (Read 2187 times)

0 Members and 1 Guest are viewing this topic.

Offline silberz

  • Member
  • Posts: 12
Horn sliver in nock question
« on: February 16, 2009, 02:33:06 pm »
I have been adding the horn sliver to the nock end but mine seem to be about 1/4 thick in a 11/32 shaft, I always read where people say to use about 1/16 thick sliver but is there any down side to using a thicker sliver of horn?
Thank you for the info
Max
Logged

Offline Justin Snyder

  • Administrator
  • Member
  • Posts: 13,794
Re: Horn sliver in nock question
« Reply #1 on: February 16, 2009, 03:10:06 pm »
Only down side I can see is that you only have about 1.5/32 of wood on each side of the horn.  That isn't really enough to even stabilize the horn and keep it from popping off the side of the arrow. Unless you cut a V where the horn and shaft meet I would go narrower. Justin
Logged
Everything happens for a reason, sometimes the reason is you made a bad decision.


SW Utah

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,507
Re: Horn sliver in nock question
« Reply #2 on: February 16, 2009, 03:54:37 pm »
I have used rawhide as a spine in reinforced nock with excellent results. One saw blade kerf and a little sanding and it it ready to glue with TBIII. I read about rawhide spines in Glenn St Charles' book, "Billets to Bows".
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC
Pages: [1]
« previous next »