Author Topic: blade material choice  (Read 5934 times)

0 Members and 1 Guest are viewing this topic.

banoch

  • Guest
Re: blade material choice
« Reply #15 on: October 14, 2009, 12:18:30 am »
The problem is that being new to all of this I have absolutly nothing of interest to trade except for a little $.

Offline leapingbare

  • Member
  • Posts: 2,028
    • http://www.flintknappers.com/jessewright/
Re: blade material choice
« Reply #16 on: October 14, 2009, 12:21:07 am »
I think stone knifes were carried for self defense as a last resort.. it would be much more practical to use blades and flacks for cutting and carving.. sure you can gut a deer with a well made stone knife.. but its much easier to do it with a flack off a blade core.  just my 2 cents.
Mililani Hawaii

Offline Jaeger

  • Member
  • Posts: 238
Re: blade material choice
« Reply #17 on: October 14, 2009, 06:35:54 am »
a flake is as sharp as it ever will get to retouch it just dulls it ,or so it sayes in waldorfs book.

Offline sailordad

  • Member
  • Posts: 5,045
Re: blade material choice
« Reply #18 on: October 14, 2009, 07:09:53 pm »
ive got scars on two of my fingerprint pads from flakes
damn near cut both of them right of the finger
happened in less than a blink of an eye too

they cut soo clean ya can bleed for two days before it quits,then ya bump it and it starts all over again with the bleeding
i always wanted a harley,untill it became the "thing to ride"
i ride because i love to,not to be part of the crowd

Offline mullet

  • Global Moderator
  • Member
  • Posts: 22,888
  • Eddie Parker
Re: blade material choice
« Reply #19 on: October 14, 2009, 09:35:54 pm »
 Brian Melton knocked off a flake of that Florida Chert, Hillbilly once called concrete. And then commenced to skinning a boar hog with no trouble at all. Anybody that has experiance skinning a wild hog knows how you have to keep resharpening your knife.
Lakeland, Florida
 If you have to pull the trigger, is it really archery?

Offline Bill Skinner

  • Member
  • Posts: 384
Re: blade material choice
« Reply #20 on: October 14, 2009, 09:53:09 pm »
Pedernales or flint.   I agree with Leapingbear, they carried a stone knife in case they needed to cut something.  If they expected to cut something, they carried flakes or spalls or something they could get flakes from.  Bill

banoch

  • Guest
Re: blade material choice
« Reply #21 on: October 15, 2009, 12:30:31 am »
OK, I found some rhyolite but the guy says that it is "mid grade" What does this mean other than it is not high or low grade? He is asking $2 lb.

Offline Hillbilly

  • Member
  • Posts: 8,248
  • I like tater tots.
Re: blade material choice
« Reply #22 on: October 15, 2009, 11:31:05 am »
Banoch, where is the rhyolite from? In NC, it ranges from a very good grade comparable in knappability to raw chert to a grainy, granite-like rock that's almost unknappable. The best stuff is green or gray.
Smoky Mountains, NC

NeolithicHillbilly@gmail.com

Progress might have been all right once but it's gone on for far too long.