Main Discussion Area > Arrows

Trade points

<< < (2/5) > >>

RidgeRunner:
10-4 Guys  and thanks
The cold chisel method will tried this weekend.
I do not have a good hack saw blade or a drimal yet.  My Birthday is comming up! ;D

Thanks
David

RidgeRunner:
Just to let everyone know the cold chisel method worked well.
It took about an hour for me to cut 16 point out of one saw blade.

Three are completely finished. They have a blade that is 1" wide and 2" long.
I made a 1/4" long reverse angle on the back of the blade that tapers to a 3/8" wide
by 3/4" long tang. 

I hope this can be understood.  Man I have got to get me some way to post photos!

Thanks
David

Pappy:
I also use a drimmel tool,mine is air it dose good I cut out a dozen in a little over an Hr.
   Pappy

[attachment deleted by admin]

Pappy:
These are 160 grain.
    Pappy

RidgeRunner:
Well one thing for sure, those look much better than what I made.
Pappy:
What type of material do you cut yours from?

Thanks
David

Navigation

[0] Message Index

[#] Next page

[*] Previous page