Main Discussion Area > Shooting and Hunting
Hit one this afternoon...
mullet:
David, I have some with glued in foreshafts and removable ones. I'll post you some pictures tomorrow.
El Destructo:
I Cheat....and Drill the Cane out and press in a Carbon Arrow Insert....so I can change Points as easy as Pie!!
hedgeapple:
--- Quote from: El Destructo on December 03, 2009, 01:35:25 am --- I Cheat....and Drill the Cane out and press in a Carbon Arrow Insert....so I can change Points as easy as Pie!!
--- End quote ---
El I've thought about doing the "cheating" method, but was afraid I'd get the drill bit in a bind and split the cane. I assume you use a drill press, do you tape up the cane also before drilling?
El Destructo:
I do use a Press...and a little Electrical Tape also...and Use the lowest pulley setting on My Press....so the Bit is going as slow as possible ...I have only had one split on me while drilling them out.....just make sure that You buy the smallest Inserts you can get
Mechslasher:
wrap the cane with a rubber band. that will keep it from splitting when you drill.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version