Main Discussion Area > Arrows

Square to round

<< < (3/3)

Badger:
   I lke that, I have quite a few versions I have made and used but plan to try that one next. I use a version of that with my tablesaw instead of the saws all blade but I hate the noise. The table saw produces a beautiful fine finsih, much better than I get with my router version. The main one I use is the tenon tool from lee valley. It does a fair job but requires some finish work. The table saw method will work with any wood and gives the best finish. Steve

StevenT:
Do you think this method could be used to flatten nodes out on cane?

Jim Davis:
Normally wouldn't suggest it here on the Primitive Archer site, but since you guys are going all mechanical anyway...

http://www.highlandwoodworking.com/dowelmakingjig.aspx





Jim Davis--Reparrow man

KenH:
I'm wondering how the simple drill rig will work rounding split bamboo into round shafts....

mox1968:
or you could try a veritas dowell cutter,stick in your vice chuck your stock in drill and feed through cost me around £25 or about $32 im thinking

Navigation

[0] Message Index

[*] Previous page