Main Discussion Area > HowTo's and Build-a-longs

Arrow taper jig

<< < (2/2)

Eric Krewson:
These jigs make a perfect tape every time.I made one with the same concept but stacked my angles on top of each other. I put a pivot in each top piece and adjusted the cut until it was perfect in both a field point and nock then fastened the angle piece securely.

Lombard:
Justin, thanks for the tutorial. I need to get one of those sanders. Do you like the Ryobi, any pluses or minuses one should think about before purchasing one?

Justin Snyder:

--- Quote from: Lombard on February 13, 2010, 06:52:05 pm ---Justin, thanks for the tutorial. I need to get one of those sanders. Do you like the Ryobi, any pluses or minuses one should think about before purchasing one?

--- End quote ---
It is cheap and you get what you pay for...... I actually like it. The only real drawback is the drivebelt is rubber and will eventually strip out. It is only about $7 to replace, but you have to order it.

Navigation

[0] Message Index

[*] Previous page