Main Discussion Area > Arrows

Giving boo a try. some questions

<< < (2/4) > >>

riarcher:

--- Quote from: Greatgoogamooga on February 22, 2010, 12:09:32 pm ---I appreciate the advice on making these arows.  Anybody have experience harvesting cane?
Goog

--- End quote ---

You're way ahead of me on these. I spent a week or better trying to figure out how to straighten the darn things,,, even with everyone's help.
I was concentrating heat on too small an area I think. All I got was burnt offerings and snapped garden stakes.  ;)
But, I have learned. All is better at bending.  ;)

hillbilly61:
What's better. River cane, hill cane or Home depot cane?  I can harvest all of the first 2 that I can handle. ;D the HD I have to pay for :(

 How long does it take for fresh boo to dry before working and shooting it?

aero86:
I personally would like to try some can.  I think using home depot bamboo is good because its more forgiving on mistakes, and you can flatten the nodes out in many ways. 

Now, to just find some cane around here...

Sweet Potato:
Hello Goog,

I've only used bamboo for arrows, its easier for me to find than wood.
My experience is limited to a few arrow making sessions, but here's what I found and did.
This is my first reply to a question so take it for what its worth, I hope you find some help here...

For straightening, heat the area to bend over low heat, keep it moving and wipe with a damp rag periodically.
My gas stove heats things up in under a minute. Bamboo will become very bendy, even rubbery when hot.
Make a tool, just a handle with a 90 degree notch (or hole) for finer bending control, and you don't need to hold the hot arrow shaft.
Don't overheat - just to where its too hot to touch is enough.
And hold the new shape until cool.

Sanding yes, sealed with a couple layers of left over gelled up wood oil.

For the nock I started each about an inch back from a node and oriented the nock 90 degrees to the natural stiffness (wider part of the shaft's oval).
To reinforce the nock and tip ends I wrapped with dental floss, whip finished and super glued. It worked very well and never frayed.
I also drilled out the center hole of loose stuff at the nock end with a small file, filled with a bamboo skewer and super glue for extra reinforcement.
These two reinforcements made for a very strong nock.

For field tips I experimented with short hex bolts with a rubber gromet between the head and threads.
Again make sure you wrap reinforce this end too. Screw bolt in straight just snug with the gromet, and it works great for soft targets.
Hit anything hard and the shaft splits after a few hits, driving the bolt into the hollow and ruining days of work.

Good luck!
Sam

aero86:
I have found using a two setting heat gun works very well when straightening this stuff.  Especially on the low setting.  Just slowly spin the shaft around and within 10 to 15 seconds, its ready to bend.  Nodes take a bit longer to heat correctly.  The outside of the bamboo will start to look. Waxy when its hot enough.  With the heat gun its a nice and easy controlled heat. Ou really have to work at scorching it to scorch it

Navigation

[0] Message Index

[#] Next page

[*] Previous page