I've been reading the dowel maker post and don't think these questions have been addressed, but pardon me if they have and I'm just too dense to see it
![Huh ???](http://www.primitivearcher.com/smf/Smileys/default/huh.gif)
If you have, or have used a shaft shooter like the one from 3 rivers, please give me feedback on how well it works; i.e. how difficult is it to adjust? Is the cost justified by the outcome vs the Veritas dowel jig (the more expensive one)?
For those of you who have the $169 Veritas dowel maker from Lee Valley Tools, do you have any trouble adjusting it to cut to 11/32 or 23/64? Is the finish decent? I already have the less expensive one, but want something a bit more precise. It's either this or the enormously expensive shaft shooter, as I'm not familiar with using a router and am not a machinist
thanks!