Main Discussion Area > Arrows
uniformly sharpening trade points
JustinNC:
How do you guys do it? I mean I can get the belt sander out or grinding wheel, but nothing guaranteeing me a uniform angle on both sides. I put one in the Lansky and with the extra coarse stone and about 500 strokes later, I have a perdy angle STARTED but not and EDGE.
Maybe I am being too particular and should just rough it out with the angle grinder and then finish with the Lansky.
Pat B:
I'd say get your basic angle with the grinder and then let the Lansky dress it up for you.
JustinNC:
Thanks Pat. Guess I over thought it and trying to be a perfectionist. It's only a point. I aint tryin to split a gnats hair at 70yds. Must be a little wheelie bowman left in me looking for perfection. I'll shake that, don't worry ;D
half eye:
JustinNC,
I'm not only old but kinda old-fashioned to boot. I was taught to sharpen my broadheads with a 10" mill-bastard file, stroking into the edge and from rear to point. From there ya can stone or hone if you want to but with a little partice them file sharp heads will really suprise ya.
Matter of fact "true-angle" (guys that make hones) make a set of mill files attached in a wood block.....just push the 2 blade threw a couple times (both sides) and yer angles are set.....and they be mighty sharp too.
Rich
JustinNC:
Half eye...there is a reason things were done the way they were done, even if it is old fashioned, and 99% of those reasons were because it WORKED. I finished roughing it one out lastnight and put a 25* edge on it....guess that's a 50* cutting angle. I think since this is just a test, I'm going to shoot it like that, see how well it penetrates, then take it down to 20/40 and see how well it does, then on down to 17/34 and see how well it does. I really want to go down to the 17/34 because you can flat out put an edge on something with a low angle like that, but just worry about chipping and bending. Will be fun to see what works best.
Here it is so far. We can't use barbed in NC, and they have to be atleast 7/8" This one is 1.5" long from tip to widest point of the head, then 1" across at the widest point. Total length is 2 2/5". Haven't gotten a weight yet.
Will also be huntin in SC as well....no restrictions on heads down there. So may do some longer more 3:1ish heads as well and make them barbed to cut out some of the weight that goes along with the thick circular saw blades.
Here's a cell phone photo...sorry for it being fuzzy
Navigation
[0] Message Index
[#] Next page
Go to full version