Main Discussion Area > Arrows

Identification Help - UPDATED (more pics)

(1/3) > >>

NorthernArcher:
I collected a bunch of Red Osier the other day, along with a couple hardwood shoots that I have used before with good results but have yet to identify, and one that I think may be some kind of rose, but I'm not sure.  We have wild rose (alberta rose) here, but it isn't any good for arrows.  I have cut several over the years, but they are always soft and thin-walled, with very large pithy centers.  This one was denser, had fewer and larger thorns, and a much smaller pith.  It looks like it will make an excellent arrow shaft.  Any ideas what this might be?  If anyone knows the name of the other shoots in the picture, I could use some help identifying them as well.  They don't grow in clusters, like Osier, but are actually small saplings that grow separately.

Thanks  :)

Tom Leemans:
Mutiflora rose?

Deo:
The one on the right is for sure wild rose, Wild rose can vary in pith depending on age and where it grows but makes a great dense and heavy arrow. Do not remove bark at least for a month or two, I usually wait for about 3 months before I remove the bark. I will however use something to flatten the thorns. The other two look like they may be service berry aka june berry. I need to see the leaves and possible the bush in order to see what it is. June berry makes good hard arrows, even small diameter shafts have heavy spines. Nice work, I would like to see them when they are done.

Pat B:
The shoot on the right might be rosa rugosa. Did it have large red rose hips(fruit)?

NorthernArcher:
I don't recall what the rest of the shrub looked like, but I'll be sure to check next time I'm down there.  The two on the left didn't come from a shrub, but were small saplings.  They grow quite a bit larger than that, and there are lots of them in the river valley.  I may have to wait till next spring/summer to get some good pictures of the foliage to share.  I have a set of arrows that I made from this stuff a few years ago, and they are quite a bit heavier than my osier shafts.  I'm looking forward to seeing how this rose shaft turns out.

Deo - thanks for the advice on the bark.  I usually remove the bark on Osier within a few days of collecting them, without any problems.  Same with the other shoots I collected.  But I have no experience with rose of any kind, so I appreciate the advice.  I'll proceed carefully with this one.

Navigation

[0] Message Index

[#] Next page