Main Discussion Area > Arrows

special design for whistle points

(1/1)

stiventiger:
for the 100% copper made for fitting 5/16" vaired shafts and weight 195 Grains each, glue-on type,you should need taper little of the point end of your arrow shafts,quite simple and easy glue on,just in few seconds to fit.
for the iron&steel alloy made for fitting 5/16" vaired shafts and weight 155 Grains each, glue-on type,uniform tube size: no need taper the point end of your arrow shafts,quite simple and easy glue on,just in few seconds to fit.
i change the whistle points head design to let each have the whistle,now in market some the whistle points can't have the whistle sounds.

Aries:
i wonder if they have any trouble with clogging if being shot at assorted targets...  card board target.. foam..    ?

oat:
It 's take down design so you can take the tip out and clean the holes.
I am wondering if the very tip part going to collapse upon impact on hard target like dead tree.

stiventiger:

--- Quote from: Aries on November 21, 2010, 08:27:05 pm ---i wonder if they have any trouble with clogging if being shot at assorted targets...  card board target.. foam..    ?

--- End quote ---
no problem,we test them a lot of time,see my ebay store describation:http://myworld.ebay.com/stmmrr1968
regards
tiger

stiventiger:

--- Quote from: oat on November 21, 2010, 10:45:28 pm ---It 's take down design so you can take the tip out and clean the holes.
I am wondering if the very tip part going to collapse upon impact on hard target like dead tree.

--- End quote ---
no problem,the tips are very thicker and stronger enough no collapse even impact rock etc,we test them a lot of time,see my ebay store describation:http://myworld.ebay.com/stmmrr1968
regards
tiger

Navigation

[0] Message Index