Main Discussion Area > Around the Campfire

New bit

(1/3) > >>

skyarrow:
Here is our new 8 3/4 oklahoma claw bit we have used claw bits for many years but this is our first step down hole opener claw we have had and made many roller style openers . So here are the stats from two different style bits ok last job we drilled a 360 ft well we did our test hole with a 6 1/4 claw bit and after that was done we opened the hole with a 8 3/4 roller bit it took 2 days to open the hole to 360 ft ok here is the next job  same depth  same test hole diameter yesterday we used our new claw hole opener it took 3.5 hours to get the hole opend to 360 ft talk about saving money that alot of deisle saved







The rusty claw bit on the end  is the pilot bit that rides inside the test hole to keep the new opend hole straight and the welded strap keeps it from unscrewing  the new hole opener is the the blue one

skyarrow:
And a side note roller bits you have to send them off to get re built and these claw bits I can re tip it in under 10 min that's a great advantage to the roller bit and it will drill rock or clay faster also

skyarrow:
Here is some roller bits for those of y'all who don't now what they are

Bevan R.:
You drilling for Oil or Gas?

Bevan R

skyarrow:

--- Quote from: Bevan R. on March 18, 2011, 04:39:24 pm ---You drilling for Oil or Gas?

Bevan R

--- End quote ---
I'm a water well driller  8)

Navigation

[0] Message Index

[#] Next page