Main Discussion Area > Bows

Draw Length

(1/2) > >>

Mechslasher:
i was finishing up an arc board the other day and started thinking about something.  the arc board uses AMO draw length but i've been using "true draw length" measurements.  who out there uses which draw length??  there is a difference of between 1.5-1.75", with AMO being longer than true draw length.

Coo-wah-chobee:
            Use what ya would call true draw length measured from back of bow ta string nock slot bottom............bob

NOMADIC PIRATE:
Who's AMO  ?? ;D

Mechslasher:
Archery Manufacturers Association (AMO)

Mechslasher:
ttt

Navigation

[0] Message Index

[#] Next page