Author Topic: spining footed shaft.  (Read 1590 times)

0 Members and 1 Guest are viewing this topic.

Offline triggerfinger

  • Member
  • Posts: 170
spining footed shaft.
« on: August 10, 2011, 08:02:25 pm »
doyou spine the boo before or after you foot them, does footing change spine.
I have nothing witty to say.......

Offline CraigMBeckett

  • Member
  • Posts: 398
Re: spining footed shaft.
« Reply #1 on: August 12, 2011, 11:26:17 pm »
Spine before then you know you are not wasting the effort on a too weak or too heavy shaft.

The footing will alter the dynamic spine, the footed area will not have the same mass as the equivalent length of bamboo.


Remember static spine puts you in the ballpark, you have to shoot the arrow (as a minimum at the distances you intend to use the arrows) to see if it suits you and your bow.

Craig.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,507
Re: spining footed shaft.
« Reply #2 on: August 13, 2011, 02:13:19 am »
Craig nailed it. Spine your arrow and consider the foreshaft as a point. AMO spine is calculated on a 28" arrow suspended between 26" uprights with a 2# weight uhung from the center. The deflection will determine the actual spine. This calculation is for a 28" arropw with a 125gr point. For every inch over or under subtract/add 5# of spine weight. Any deviation in point weight will change the effective spine weight too. You will have to consider your foreshaft with your point weight.
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline triggerfinger

  • Member
  • Posts: 170
Re: spining footed shaft.
« Reply #3 on: August 16, 2011, 01:02:37 pm »
thanks guys,  you are helpful as always. 
I have nothing witty to say.......