Main Discussion Area > Bows
Glue test
gpw:
Thanks for the tip!!!! .... we made alot of bows with Tightbond II , never had a problem and we're making reflexed bows......Can't wait to try T III.. ;D
tom sawyer:
I always went with the URAC or resorcinol, just because of their gap-filling properties. Plus its easier to prep surfaces for those glues, as they are supposed to be rough. Titebond type glues require smooth, well-mated surfaces right? Unless you are in Hawaii. hehe
Pat B:
Lennie, That's what they say but like Manny, my glue joints leave a lot to be desired. :o Never had a backing fail due to a glue joint. Pat
NOMADIC PIRATE:
If you see the gaps on the BBG used in the test, you would laugth your head out :o :o in some places I filled with a splinter of Boo after the glue up was done !!! I should send this bow out for everyone to see :D :D :D :D
Pat B:
I usually go around the glue joint with super glue to fill the voids. ;D Pat
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version