Main Discussion Area > Arrows

Poplar shaft straightening

(1/2) > >>

armymedic.2:
i have 2 dozen poplar shafts that i ordered from 3 rivers.  I immediately noticed that they were much rougher than a cedar shaft on the outside surface.  I also noticed that they were not all straight, and the ones that weren't did not like to be straightened with pressure. My ace roller does a great job on cedars, but nothing to the poplar.  Any suggestions?  is this typical of poplar shafts?  I wanted them because they are supposed to be more durable and heavier than cedar, but if they aren't straight they aren't worth a dang!

Hillbilly:
Try straightening them with heat. I sometimes make poplar shafts from scratch, and they stay straight really well if split from good straight-grained stock.

Kegan:
Heat always works for me on crooked hardwoods arrows. Pressure works when they are green and drying, but heat makes it much easier when they are seasoned.

armymedic.2:
is it okay for me to use heat on finished arrows.  i have three that are already coated in finish, and they are pretty crooked.  It is quick dry stuff from 3 rivers.  Thanks guys.  Using heat, do i need to hold them straight until they cool?

sonny:
you might be able to get 'em straight by burnishing the outside bend where they're crooked. by compressing the wood fibers it effectively pulls out the crook.
burnishing might scuff the finish depending on how brittle it is...much better to straighten before applying finish.  ;) 

 

Navigation

[0] Message Index

[#] Next page