Information and Resources > Trading Post

Looking for Rivercane 1' wide or more for blowgun

(1/3) > >>

Stalkingfox:
looking for some rivercane thats at least an 1" wide and at least 3' long. multiple pieces. also looking for long straight honey locust thorns 6-8" long

1442:
I can get some cane 1" diameter but I don't think its river cane. It is actually straighter, the nodes are farther apart and there is practicaly no flat spots at the nodes. Its weaker spine than rivercane like for arrows but the 1" diameter will be real stiff and its thick walled like rivercane.
Probably better for a blow gun than rivercane unless you just have to have the river cane. I've not actually cut any that big but I think there are some that are mighty close if they aint a inch. I can go check it out on Tuesday if you're interested.

bowtarist:
IfI remember, I'll take some snips and take a walk later today. There is a big HLocust in the next field over from my place. I'll see if it has any that long. That seems pretty long though. Will you be cutting off the two horizontal spines to get the 6/8" length?  I'll see what I can do, how many do you want/need? dp

p.s. If I get these for you and if 1442 gets you the cane, you'll need to do a build along for all to see how it's done.  ;D

1442:
I worked until dark today and didn't make it to the cane. Will soon.

1442:
OK I looked at the cane and the biggest was only about 3/4 inch. Too bad because its really nice cane.
At work today putting on a metal roof I spied a bamboo patch along a drainage ditch and went and checked it out. I cut a few pieces from about 1 inch to 1-1/8, but it is bamboo with closer nodes and a flat spot the entire length of the innernodes. The boo was over 20 feet tall and holds its diamiter well with pretty thick walls.
If this would work for you, PM me and we'll go from there.
Otherwise I'm gonna keep my eyes peeled for some large cane.

Navigation

[0] Message Index

[#] Next page