Main Discussion Area > Arrows

Bone Head Arrows

<< < (4/4)

PK:

--- Quote from: DanaM on January 13, 2008, 08:23:28 pm ---PK be careful sanding the nodes down, you can seriously weaken the shaft if ya go to far. :o

--- End quote ---
Good Idea, Thanks, I did that on a boo bow I attemted to break.

Pat B:
What I do with the nodes is heat them and compress them by rolling them on a hard, smooth surface under a hardwood block. You can make them about the thickness of the internode area and not loose any strength. The nodes are a cane arrows weak link so I try not to remove any critical material from them.     Pat

Dingleberry:
Cool arrows :)

PK:

--- Quote from: Pat B on January 14, 2008, 01:41:37 am ---What I do with the nodes is heat them and compress them by rolling them on a hard, smooth surface under a hardwood block. You can make them about the thickness of the internode area and not loose any strength. The nodes are a cane arrows weak link so I try not to remove any critical material from them.     Pat

--- End quote ---
Thanks pat I will remember that, I buy my shoots from the hardware store so I don't know where they come from, all I know is they sure pack a wollop.

Navigation

[0] Message Index

[*] Previous page