Main Discussion Area > HowTo's and Build-a-longs
Building the Vine Maple Bow - Finished
Gordon:
Over the course of a week I have shot several hundred arrows through the bow to ensure the bow's durability and test the tiller. The tiller changed slightly and I made a few minor adjustments.
I start the sanding process by wrapping a piece of 150-grit sandpaper around a nock file and sanding the string groves. I also use a piece of folded sandpaper to slightly round the edges of the string grove.
When the nocks are done, I'm going to sand the bow using progressively finer grit sandpaper, i.e. 100, 150, 220, and 350 grit.
Gordon:
For my first pass with 100-grit I use a sanding block to remove any tool marks from the belly and edges. After that I sand freehand.
Periodically I wipe the bow with mineral spirits. The mineral spirits accentuates any scratches or tool marks that I might otherwise miss. I'll go over these imperfections with sandpaper or a scraper until the bow is completely free of any marks.
Gordon:
When the bow is sanded I prepare the dye by mixing equal parts of medium brown and green dye in an alcohol and shellac solution.
I wipe on the dye using a sponge brush and remove any excess with a clean rag.
After letting the bow dry for an hour I remove any raised grain by going over the surface lightly with 350-grit sandpaper. Once the surface has been lightly sanded, the grain will not raise again and I'll brush on another coat of dye.
Gordon:
I'm going to use a wipe on Urethane for finishing the bow. This finish is self-leveling (it won't run), it does not attract dust particles and it is very easy to apply.
Using a foam brush I apply the finish liberally on both sides and edges of a limb. I take a clean rag and wipe off the excess leaving enough finish on to give it a wet appearance. I do the same for the other limb and handle area and that's all there is to it! I let the finish dry overnight.
When the third coat of finish has been applied and cured I lightly sand the surface using 350-grit sandpaper. I Use very light pressure and don't make any more passes than are necessary or you risk sanding completely through the finish.
After sanding, I wipe the bow down and lay down another coat of finish. I'll put a total of 6 coats of finish on the bow.
Next up - rubbing out the finish
Gordon:
I have applied six coats of urethane to the bow and am going to rub out the finish to get that silky satin look. Before rubbing out the finish I let it cure for at least 2 days to make sure it is well hardened. I will use the following materials to accomplish this (from bottom to top) 400-grit wet/dry sandpaper, synthetic steel wool, and powdered pumice stone.
I start by sanding over the finish using 400 grit wet/dry sandpaper and water. I am trying to get the micro grooves out of the finish and make it perfectly smooth. Be careful to not sand too much or you risk going all the way through the finish. As you sand you should see a slurry of water and finish develop. Wipe this off with a rag before going to the next step.
When the limbs are thoroughly dry, I rub the limbs down lightly with a patch of medium synthetic steel wool. I wipe the limbs off and then do the same with fine synthetic steel wool.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version