Main Discussion Area > Flintknapping

You know what they say...

(1/2) > >>

Ghost Knapper:
If at first you don't succeed try and try again. 4th time was the charm, finally finished a calfcreek/andice point.

Thanks to Outbackbob for showing me how he punch notches.

Outbackbob48:
Joel, Very very nice. I knew that you could do it and they seem to get easier after a few whoops. Great lookin point..  I had to come back and look again and I see ya got the nice C shaped flakes thinning ahead for ya, Bob

Ghost Knapper:
Well that was one thing I found interesting most of the flakes did not have the classic C shape to them. To get the most control I could from the punch I used a small vice with rubber on either side to hold the preform while I punched out the notches. So the whole time the base and both ears were not supported at all. I did have to take it out each time after removing a flake to clean up and square everything up so it wasn't the quickest method but it worked.

1442:
Really nice Andice point,
I like it a lot

AncientTech:
That is awesome Ghost Knapper,

If you are looking for the deep C-bulb notches, I would suggest using the edge of a coarse stone biface as a punch.  You can put the edge of the biface into the notch, and rap the back edge of the biface.  It is better to use a really coarse grade biface, so as to minimize breakage of the biface.  Also, I think that a small ovate biface works well for this type of punch.  If the shape is ovate, there is less risk of burinating the tip, with a sharp blow.

I believe that there is another type of punch, in the archaeological record, that was used for the same effect.  It looks like a small peg, with a beveled end that looks like a blunt screwdriver. 

I have not yet tried the latter tool.  But, I have seen it in archaeological reports, over the years. 



Ancient Tech

Navigation

[0] Message Index

[#] Next page