Author Topic: how to lay bamboo back over a recurve  (Read 1444 times)

0 Members and 1 Guest are viewing this topic.

Offline sleek

  • Member
  • Posts: 6,740
how to lay bamboo back over a recurve
« on: March 15, 2016, 09:41:22 pm »
I am repairing the back of that attempted shot bow that lifted a splinter. Its recurved and hetting boo to lay in that radius seems difficult. I see a few options. Boil the boo and curve it to match, thin it so thin at the tips it bends with little to no force. Bitnifnits that thin,  screw it and terminate it at the hooks with a wrap.

Any suggestions?
Tread softly and carry a bent stick.

Dont seek your happiness through the approval of others

Offline PatM

  • Member
  • Posts: 6,737
Re: how to lay bamboo back over a recurve
« Reply #1 on: March 15, 2016, 09:50:57 pm »
You can bend boo by aggressively heating the outside with a heat gun.  Try it with a few scrap slats.

Offline bushboy

  • Member
  • Posts: 2,256
Re: how to lay bamboo back over a recurve
« Reply #2 on: March 16, 2016, 04:39:59 am »
I have clamped bamboo to a recurve and locked in the shape with a heat gun also.try to keep the nodes out of the tightest parts of the hooks if possible.
Some like motorboats,I like kayaks,some like guns,I like bows,but not the wheelie type.

Offline John Scifres

  • Member
  • Posts: 65
Re: how to lay bamboo back over a recurve
« Reply #3 on: March 16, 2016, 12:17:31 pm »
Your boo should be as thin as you can get it.  Cut it to profile.  Thin it with a planer or plane until the sides are nearly sharp, certainly less than 1/16" thick.  It should easily conform to the shape.  If not, a heatgun gently used should encourage it to do so.  Your broken bow's back has to be dead flat.  Good luck.