Main Discussion Area > Flintknapping

What am i doing wrong

<< < (2/3) > >>

sleek:
It was a curved piece, and i am trying to learn to shoot flakes from the hallow sode to flatten it. I can shoot them over the top just fine, but unerneath doesnt want to.

GlisGlis:
Sleek I am at a stage similar to your but slowly seeing the light
for me the trick is to make concave side first.
I try to start with short flakes until some sort of convexity is set and then start to try longer flakes

Redhand:
Sleek I don't see anything wrong.  It takes a lot flaking to get a flake pattern across the concave part of a point.  Flakes just don't travel well across convexity.

Stringman:
Flakes don't travel through concavity. They will stop and hinge or dive through and break the point all together. With little points like that you have to address the major things first.

With a curved flake like that I would have tried to flatten the hump out and take the wings off the concave side and get as flat as possible. Then see what's left before styling your point.

All that said, your points are looking better and showing progress. Keep it up Kevin!

Outbackbob48:
Sleek, you need to keep building convexity to the concave side so flakes can travel further. Don't try and run flakes all the way across on first couple of passes on concave side just run short flakes raise edge and run another set  a little further raise edge again and run another set of flakes until they start coming past center, You have to build convexity so flakes will travel. Hope this helps and ya your going to lose some width :(   ps. Redhand not knit picking but flakes do like to travel across convex side or the hump ;D   Bob

Navigation

[0] Message Index

[#] Next page

[*] Previous page