Information and Resources > Trading Post

I need a 85-87" stave

<< < (2/3) > >>

PEARL DRUMS:
How about a spliced handle, Chuck? Is that feasible with your project?

Stringman:
It has a little wonkiness to it.



Its narrowest point is around 74".

JoJoDapyro:
Chuck, your in box is full. I have a Siberian elm log if that would work. No promises that it would work. It has been cut for two years, bark on.

loefflerchuck:
Thanks everyone for your replies. Marc, if you pm me your zip code I can see if it is even possible and if so the cost. Looking at the USPS site it looks like we can ship 85" from the lower 48. Clint, I wanted to try and get a solid stave for bend through the handle. You have hooked me up nearly every trade I have done here and I've always been very happy. Don't feel bad letting someone else in. Stringman, If I can't find a strait stave in the next few days I will take you up on that one. It will just take a bit of straitening work. Joe, I made some room in my message box. If your stave worked I could pick it up next time I am in SLC.
Thanks again

MWirwicki:
I'll check too, Chuck.  I may have some osage that would do you well.

Navigation

[0] Message Index

[#] Next page

[*] Previous page