Main Discussion Area > Arrows
What to use for target points?
loon:
--- Quote from: jeffp51 on April 12, 2017, 02:46:08 am ---
--- Quote from: loon on April 11, 2017, 04:41:43 pm ---I tried using duplex points but it's damn hard to drill a hole straight into a wooden shaft... will end up going through a side...
If I figure out a way to make a jig that makes it easy to drill centered holes into shafts, maybe I'll use duplex points for wood arrows one day.
--- End quote ---
I like to use brass nuts on threaded rod. the brass can be ground down on a a belt sander or bench grinder to make a really pretty point, and the lenght of rod can determine the point weight. I have the same problem drilling into wooden shafts. I made a jig by drilling half way into a piece of wood the same diameter as my brass nuts. I then wedged three nuts into the base of the hole I drilled. then I drilled the rest of the way through the wood with a bit that passes through the center of the nuts. If your hole is deep enough, you can place a shaft in it and drill from the other end of the jig back into the shaft, which gets it pretty centered. If you are patient, you can tap the resulting hole and have a removable point on your arrow. if you are not patient, use a second drill bit to widen the hole a little and then glue in the threaded rod in the shaft. It works pretty good, but not absolutely perfect unless you are careful about lining things up.
--- End quote ---
Sounds cool, got pics?
jeffp51:
It took me a while to get around to posting. Here is a picture of the points I make, and the jig for drilling a centered hole. The brass nuts are seated at the bottom of the hole and then drilled straight through the center. You still have to make sure the arrow shaft is as straight in the guide hole as possible, and if I did it again, I would seat the nuts deeper--although if you have tapered shafts, then there is a problem getting them to fit.
On the other side of the jig is the guide I use to cut a hole for the end of the self nock, so I don't have to measure every time to make consistent nocks. I just push the nock end in flush, and drill through the guide hole. Then I cut down to the hole and file until it fits my string.
penderbender:
That's a cool jig jeff. Gonna make me one of those. Cheers- Brendan
jeffp51:
I used two pieces of 1x pine and squared up all the sides. that helped me center the various guide holes I had to drill. Hardwood would probably work better, as it would hold up to use, but I had pine. I also discovered how much a drill bit can drift if it isn't sharp and I push too hard on the press.
DC:
Good thinkin' and a lot cheaper than the metal lathe that I use ;D ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version