Main Discussion Area > Arrows

Bohning fletcher instructions?

<< < (2/3) > >>

PaulN/KS:
Thank you Sir.  :OK
All I really need to see is how the nock index parts are supposed to all go together inside that knob dohicky...

Adam:
I think it may be made about the same as the Grayling fletching jig.  A Google search for "using Grayling jig" brings up some good info and videos.

If you're unsure about what you're doing as I was at first, I found it helpful to wrap some double sided tape around the arrow shaft and do a trial run before using glue.  That saved me a lot of headaches in the initial setup.

osage outlaw:
I forgot to get some pictures.  I'll try again tomorrow morning

osage outlaw:
I hope this helps you out.  I marked the cock feather position on the knob.

PaulN/KS:
OK, I think I can figure it out from that.
The spring goes inside the knob and then it all is held together by that little screw.
Thanks.  :OK

Navigation

[0] Message Index

[#] Next page

[*] Previous page