Main Discussion Area > Arrows

cresting jig

<< < (4/4)

PEARL DRUMS:
This one is cordless, I like that.

Aaron H:
That'll do nicely

lebhuntfish:
A buddy of mine has one that I have used.  He got it off of eBay but it was home made.  It used a small shaded pole motor and the shaft run on the edge of a roller blade wheel.  There was a rubber grommet inside the roller blade wheel that griped the arrow shaft.  The support for the shaft was a pair of small wheel bearings  mounted side by side.  It had a dimmer switch on it but I never used it to adjust the speed.  Ill see if I can find a picture of it.  Not sure I have one. 

Patrick

Hawkdancer:
I done been outdone!  Mine is manual.  Got no old slow motors laying around, except me.  Got to relearn how to get my pictures out of Imgur, then I can post 'em.
Hawkdancer

Hawkdancer:
https://i.imgur.com/IlkDPtE_d.jpg?maxwidth=640&shape=thumb&fidelity=high
Hope this works!  I may get real practice.  I think you need to click the code to see the pics.
Hawkdancer

Navigation

[0] Message Index

[*] Previous page