Main Discussion Area > Arrows
Making matched arrows
Danzn Bar:
Looks good but I'd put a little more thread wrap around the end of the shaft. Just incase I hit any brick walls...:) :)
DBar
DC:
I use Kevlar thread and I cut a shallow groove in the shaft for it to sit in. There is more thread than it looks like and it's stronger thread. It's sorta flush with the surface so it pulls out of the target without a lot of fuss or noise.
BowEd:
Very nice looking arrows.
DC:
Not as nice as yours Ed :D
Aaron H:
Very nice DC, I'd say from those numbers they'd make a good consistent set.
What do your points weight?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version