Main Discussion Area > Arrows

TSA raffle drawing shafts.

<< < (4/8) > >>

JonW:
I was also a winner of the giveaway. Very nice product from TSA. Thanks Wayne!!

TSA:
You are most welcome, my friend!! :D

TSA:
You are correct Beadman, you wont get the same %ages as with the ultra light carbons (can we even use that word on here  ;) )
Putting a tail taper on the spruce will help a bit more too! ;D

Pat B:
Wayne, how much rear taper do you add to your shafting. I tapered some poplar shafts I had and loved the way they shoot. I think I put 8" or 9" from 11/32" to 5/16".

TSA:
what i do, and this is not cast in stone- but just what works for me- i taper anywhere from 1/4 to max 1/3 of total shaft length after trimming to my personal length, also taking the 11/32 down to 5/16.
i have always gone by the rule that the middle third is what contributes mostly to the spine. just looking at how the shaft bends.

but i  am sure some technologically more advanced soul will have better input than my thumb suck ideas! :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page