Main Discussion Area > English Warbow

acceptable strapping/tiller advice

(1/2) > >>

stuckinthemud:
Hi guys,
this longbow is currently 40# at 18" (bottom pic), I'd like it to draw to 28 (length is 73" ntn) but the handle is bending and trying to pop off the capping piece on the handle.  The cap is an 8" long piece of apple sapwood, rings are not violated, 3mm thick at its centre, feather-edge at the ends.  It was glued with 5 minute epoxy and 6 clamps, both sides were 'buttered'.  I've already had to cyano the ends and temporarily strap with cello-tape twisted and pulled very tight as they are lifting when the bow is drawn to 18".
low brace (3")


drawn to 18"


It very much looks like I will permanently need to strap the ends of the cap down; is this acceptable in the UK archery scene? If so, how would I do that? Presumably I still need the centres and outers of each limb to bend more to take the stress off the handle?

Del the cat:
If it's wrong now, it will be even more wrong at full draw.
IMO rasp it off flat and put on a longer thicker "Cap" that fades out to nothing, stuck with Resintite or some other decent glue.
It would seem the bow is bending too much at the centre so the only real answer is to add more wood to the centre (maybe a belly patch too?) or take it some off the belly at the outer limbs.
If you insist on wrapping it, I'd suggest linen thread which then has low viscosity CA on it to soak in.
Del

stuckinthemud:
A belly lam might be the better option, any idea on how long it might need to be?

Del the cat:

--- Quote from: stuckinthemud on October 11, 2017, 08:57:13 am ---A belly lam might be the better option, any idea on how long it might need to be?

--- End quote ---
The problem is that in the pic the left limb looks thicker than the centre. It could just be an optical illusion (not the best pic and the shadow plays havoc!), but it looks like it goes thin from half way along the left limb all the way to the grip... I'd suggest getting some verniers on it and checking the thickness taper, aiming for about 2mm every 6"
I've marked in yellow where it looks thin to my eye... and I may well be wrong...
If you add a nice slat of say 4mm tapered down to say 2mm either end it should give you enough to play with, but more may be better, after all you can take it off easier than putting it on, but on the other hand you want some flexibility in the slat so that it will conform to the flattened belly and give a good glue line... and again it depends how much you need to take off to flatten the belly.
Del

willie:
Stuck,
I like my tapers to be plus or minus .5 mm of design, Although I do see where some warbow guys like to side tiller more than others.

P.S. I read your thicknesses from the table in the other thread

Navigation

[0] Message Index

[#] Next page