Main Discussion Area > Arrows

hazelnut arrows.

(1/2) > >>

Jackpineboyz:
So I finally cut some hazelnut shafts last month, they are debarked and I tweak them once a week, so they are starting to look like shafts.
My next step was to heat them and do final straightening and trim them to length.
I had planned on just sanding them to smooth them out, but see a lot of people size them as well.  Is sizing needed?  Or is it just to make things uniform?  Part of the appeal to me of shoot arrows is that they are all different.  I am seasoning some nice hickory to make shafts with a shooting board.  The hazelnut is naturally tapered and the shafts are all similar, so I would think that the sizing could be skipped.  Between the kids and I we can use pretty much any spine so I figured to group them based on how they shot rather than spinning these.
I've been reading TBB and Hamm's book plus the various videos, but wanted to check that my plan was reasonable.

Pat B:
When I make sourwood arrows I don't size them unless the shoots are too big in diameter then just enough to reduce the diameter. I also like the look of natural shoot arrows and they can fly as well as any arrow.  (SH)

Hawkdancer:
I think sizing helps with pulling the weight into tolerances you may want.  I like my arrows somewhat matched for weight as well as spine for each bow.  Sizing May or may not affect spine very much, but I am no expert.
Hawkdancer

Pat B:
With a naturally tapered shoot you can reduce the actual spine weight by 10# just for the taper.

Jackpineboyz:
I'll leave natural for now and see how it goes.
thanks for the quick replies.
 )P(

Navigation

[0] Message Index

[#] Next page