Main Discussion Area > Arrows
Dowel rod cutter drc from Russia (ebay)
TSA:
i will see if i can get some pics of how my veritas was set up- it may help a bit- works a a wee bit easier than his in the video.
looks like a good tool- keep the blade razor sharp- max rpm you can get to spin it- i bought a 1/2" drill that had good speed, then a slow feed rate- i would take about 1 minute per shaft- was the ideal speed.
and as the shaft exits, you can sand it at the same time- one pass all is done!
Mesophilic:
Please do, TSA. I've fought and fought my Veritas. I can get usable shafts out of it but most often I have a spiral cut into it or other issues.
TSA:
ok will have to wait until my 15 year old daughter gets home from school- so she can take the pics etc-
bit of a techno-peasant- sorry!
when setup they produce beautiful shafts. will see if we can figure this out!
Archeryrocks:
--- Quote from: dieselcheese on February 14, 2018, 01:01:41 am --- Is it this one?
--- End quote ---
it is very similar but it is actually in imperial rather than metric, but it is probably from the same maker.
Archeryrocks:
IT'S HERE. I don't have a table saw right now because my motor went out on mine. But I took some shoots that I had dried out and ran the fat ends through after they were straightened. In just messing around I turned out 2 nice arrows. That spine great with my 58 lb Osage self bow at my 24 inch draw. (SH) :NN
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version