Main Discussion Area > Arrows

Cattail leaf quiver

(1/2) > >>

Mo_coon-catcher:
I finally got around to trying to weave some cattails I harvested a couple years ago into a quiver. This was my first attempt so I had to learn a few things as I went. But I think it turned out decent enough. I’m not too concerned about some of the flaws as this will be a wall hanger piece for my Grampa. But I think it’ll still be solid enough to be used.
A question though for te next few I do that will be used and probably hunted with. After it fully dried the falling between the leaves opened enough to be able to move. It’s not enough to hurt the function, just enough to notice it.  Can I soak in some linseed oil to both water proof and swell the leaves back so they don’t wiggle as much?
I will also change how I did theiught to finish out nicer and probably a bit tougher. Though I do like the bottom, and I did it that was since I was afraid the cattails wouldn’t handle the bend needed to make a solid bottom without creasing and becoming to delicate. I just put a wad of grass in the bottom to keep the arrows from poking through.

Thanks for looking,
Kyle

Trapper Rob:
That turned out very nice.
Did you soak them before you started weaving?

Mo_coon-catcher:
I have more soaking the same way now. I spray them down then wrap them in a tarp to hold the moisture. Onced wrapped in the tarp I set it in the sun for a day and spray them periodically. I still had trouble with the leaves kinkin as I worked themed but it was tolerable once I figured out how to manipulate the leaves.

Kyle

Hawkdancer:
You might be able bend them to shape before drying.  Or weave the flat bottom before hand then add the tube.  I am not up to speed on basket weaving, though.
Hawkdancer

Ryan Jacob:
I wonder if you could do this with yucca? The tips might not be stiff enough though

Navigation

[0] Message Index

[#] Next page