Main Discussion Area > Muzzleloaders
Christian Springs Rifle
Mike Yancey:
I made the side plate and am ready to inlet it and do the moldings around it.
Mike Yancey:
Side plate is finished and all inlet.
Got the lid pretty much fitted and done. I still need to drill and install a couple of tiny screws on the brass end of the lid. Then make the catch spring work.
Mike Yancey:
Starting to do a little carving, still have a bunch of cuts to clean up before I'm done on this section.
chamookman:
Nice :OK. Bob
Mike Yancey:
Starting to carve around the tang.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version