« previous next »
Pages: 1 [2]

Author Topic: New steam set up  (Read 3959 times)

0 Members and 1 Guest are viewing this topic.

Offline PaSteve

  • Member
  • Posts: 816
Re: New steam set up
« Reply #15 on: August 30, 2018, 07:48:22 am »
Clint, radiant insulation wrap may be good insulation. It's only about .250 thick and has an R5 rating. A couple wraps, tape it up and you could slide it on and off. Good luck with whatever you do.
Logged
"It seems so much more obvious with bows than with other matters, that we are the guardians of the prize we seek." Dean Torges

Offline osage outlaw

  • Member
  • Posts: 11,952
Re: New steam set up
« Reply #16 on: August 30, 2018, 07:53:53 am »
Is that the foil bubble wrap stuff?
Logged
I started out with nothin' and I still got most of it left

Offline BowEd

  • Member
  • Posts: 9,390
  • BowEd
Re: New steam set up
« Reply #17 on: August 30, 2018, 07:54:10 am »
Nice set up Clint.
Logged
BowEd
You got to stand for something or you'll fall for anything.
Ed

Offline PaSteve

  • Member
  • Posts: 816
Re: New steam set up
« Reply #18 on: August 30, 2018, 03:02:24 pm »
That's exactly what it is.
Logged
"It seems so much more obvious with bows than with other matters, that we are the guardians of the prize we seek." Dean Torges

Offline Selfbowman

  • Member
  • Posts: 2,922
Re: New steam set up
« Reply #19 on: August 30, 2018, 09:37:11 pm »
Well what about double walling the pipe. Arvin
Logged
Well I'll say!!  Osage is king!!

Offline JNystrom

  • Member
  • Posts: 240
Re: New steam set up
« Reply #20 on: August 31, 2018, 04:16:18 am »
Excellent idea, like stated earlier! I might just take some ideas from this to my own setup... :OK

Can i ask, what was the problem with a pvc pipe, since you wanted to change it?
I was thinking a plumbing pvc pipe would do just fine. Or will it get too hot and actually melt/lose its form?
Logged

Offline DC

  • Member
  • Posts: 10,396
Re: New steam set up
« Reply #21 on: August 31, 2018, 10:02:06 am »
Pvc bends if it isn't well supported. I've never had it melt but a 4' piece of 4" sagged big time when supported at the ends. I think a "V" trough would work.
Logged
Pages: 1 [2]
« previous next »