Main Discussion Area > Arrows
Trade point
dylanholderman:
Sounds to me like you’re just not sharpening far enough even my mild steel trade points will take a paper cutting edge pretty easily
JesseBeaux:
--- Quote from: dieselcheese on September 09, 2018, 10:04:28 pm ---
--- Quote from: JesseBeaux on September 09, 2018, 12:56:18 am ---Hey guys,
I've been making some nice Trade points from older saw blades lately and they come out real nice! However, I can't get the darn things sharp.... Tried single and tried double bevel! Tried file, Stone, and Lansky system.... Nothing working for me.... Any advice?
--- End quote ---
When you sharpen, are you getting a burr along your edge?
Problems with mystery steel and heat treating is that without knowing the chemistry of the steel, the heat treat is a shot in the dark. Have you tried a snap test?
--- End quote ---
Yes I am getting a bevel
Mesophilic:
--- Quote from: JesseBeaux on September 10, 2018, 09:13:21 pm ---
--- Quote from: dieselcheese on September 09, 2018, 10:04:28 pm ---
--- Quote from: JesseBeaux on September 09, 2018, 12:56:18 am ---Hey guys,
I've been making some nice Trade points from older saw blades lately and they come out real nice! However, I can't get the darn things sharp.... Tried single and tried double bevel! Tried file, Stone, and Lansky system.... Nothing working for me.... Any advice?
--- End quote ---
When you sharpen, are you getting a burr along your edge?
Problems with mystery steel and heat treating is that without knowing the chemistry of the steel, the heat treat is a shot in the dark. Have you tried a snap test?
--- End quote ---
Yes I am getting a bevel
--- End quote ---
Ok, but are you getting a burr along the edge itself? Not trying to sound snarky or anything. I've sharpened a lot of steel, and every once in a while the burr just rolls over the edge. Makes the blade feel like a dull butter knife. Stropping to get the burr off will generally get it shaving sharp.
Navigation
[0] Message Index
[*] Previous page
Go to full version