Main Discussion Area > Arrows

Horn reinforcement

<< < (2/3) > >>

Mafort:
You’d be correct in assuming these are for arrows. I would prefer horn as it’s a tad bit easier to work (Atleast from my experience). There’s a guy the has horn blanks that are about 1/8in thick. Would that work? He’s also got some that are .300 thick.

Pat B:
1/8" is a bit thick but will work.

PEARL DRUMS:
You can sand the thickness down by reverse wrapping duct tape around two fingers, then lay some sandpaper on a very flat surface. Grab the horn slab and stick to the tape for easy sanding.

Mafort:

--- Quote from: PEARL DRUMS/PEARLY/PD/DRUMS on October 25, 2018, 10:42:53 am ---You can sand the thickness down by reverse wrapping duct tape around two fingers, then lay some sandpaper on a very flat surface. Grab the horn slab and stick to the tape for easy sanding.

--- End quote ---

Now that’s how you adapt and overcome right there

PEARL DRUMS:
In this hobby that is a constant.

Navigation

[0] Message Index

[#] Next page

[*] Previous page