Main Discussion Area > Arrows
Block of wood 2, build along
DC:
So I should start with 8 or 9 ;D ;D
jeffp51:
make it an even dozen to be sure. :D
Swampman:
When I break a shaft, that is when I know I should probably set the project aside and come back to the project later.
Knoll:
--- Quote from: TSA on December 11, 2018, 08:02:01 am ---i have a similar craftsman saw ( not as old though :D) , and if you ever need too, its really easy to make a simple sled for them.
just cut a strip of hardwood that will fit the miter slot in the table top, nice and snug, but will still move freely, and screw that to a piece of scrap plywood- attach some toggle clamps and its done!
--- End quote ---
And ya can often use thin plywood for your sled base, thus maximizing cut height of saw.
DC:
And instead of screws or clamps 5 min epoxy works. It's thick enough to bridge small gaps so you can square things up. It doesn't soak in so it cleans right off. Sometimes it even peels off. And most importantly if you screw up the saw goes right through it, no harm done. ;D ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version