Main Discussion Area > Bows
New project
sleek:
Also, once the right limb has come around to match the left, if you have any distance left to gain, and i expect you will, id work the outter limb to mid limb on them until you have gained one more inch of draw. I dont feel they are bending quite enough.
sleek:
Further inspection, i believe the right limb also is bending more in the inmer limb than needed, try a few scrapes on the mid and outter, focusing on the outter. You actually have a bit of a flat spot on the outter right.
sleek:
...
sleek:
He is either tillering, or trying to figure a way to politely tell me to shut up....
DC:
--- Quote from: sleek on March 21, 2019, 06:59:38 pm ---He is either tillering, or trying to figure a way to politely tell me to shut up....
--- End quote ---
Actually I was making and eating supper ;D ;D
I did this. I couldn't rotate the picture in fine enough increments. You can see the tips don't quite line up. But it shows that I'm pretty close. I had to work the fade of the left to catch up with the hingey spot. After looking at the picture do you still agree with your last post. I'm going to look at it for a bit.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version