Main Discussion Area > At the Forge

Getting a sharp edge on some trade point.

<< < (2/2)

Handforged:
Question: You said you made it form high carbon steel, did you heat treat it or was it already hardened?  Reason I ask is if it has been hardened you're not going to cut it with a file (or you shouldn't be able to). You'll need to get the bevel angle started with a belt sander taking care to keep it cool, not let it turn colors, thus removing the heat treatment.

If you sharpen them to something close to a 30 degree angle you can sharpen them with just about anything. Sharpening stone, Lansky setup...whatever.

Mr. Woolery:
You asked how we would get that razor edge. My approach is to establish the bevels with my belt sander and a 220 belt. I use a sharp belt because it develops less heat. Next, I go to a soft Arkansas stone until I’ve got all the 220 scratches polished off. This takes a few minutes on a hard knife. Less for smaller items, of course. Next I use a hard Arkansas stone. This only needs a few passes. Finally a strop charged with green compound.

You can take hair off the arm with just the belt and soft stone, but the added polish makes for cleaner cutting with carving tools.

Not saying my way is best, but it works.

Patrick

Hawkdancer:
I use the Lansky diamond set if the bevel is set.  Got a "slow" grinder for setting the bevel.  Saves time if I get the angle right.
Hawkdancer

Navigation

[0] Message Index

[*] Previous page