Main Discussion Area > Arrows

Bohning tape won't stick

<< < (2/3) > >>

WhistlingBadger:
Pat, I always wrap fore and aft with silk thread coated in TB3.  That's holding up fine.  It's everything in between that's screwed up.

I reglued a few of the greased arrows, just putting glue into the loose parts with a tooth pick and pressing them in place.  I did two with TB3 and two with duco.  Shot each a few times, and both seem to be holding up OK.  TB3 maybe a little better.  Time will tell.

gutpile:
probably just gonna have to spiral wrap complete fletch on greased shaft.. won't come off then but .... it makes arrow whistle louder... TRUTH...gut

Hawkdancer:
Fletch first, then grease?  I would go with the wrap to secure.
Hawkdancer

WhistlingBadger:

--- Quote from: Hawkdancer on July 02, 2020, 12:20:59 am ---Fletch first, then grease?  I would go with the wrap to secure.
Hawkdancer

--- End quote ---

Well, yeah, normally.  I didn't realize my adhesive was coming loose until after I'd greased them.

JEB:
What is the purpose of greasing your arrow shaft?

Navigation

[0] Message Index

[#] Next page

[*] Previous page