Main Discussion Area > Horn Bows
My advanced Selfbow 45# @ 28"
simk:
thanx for nice comments dudes. glad you like it.
Andrew: this time I was too lazy to glue the horns with the hide glue stuff and used some of the expensive epoxy instead (-S
Del the cat:
Very cool bow
Del
sleek:
--- Quote from: simk on September 14, 2020, 10:10:01 am ---thanx for nice comments dudes. glad you like it.
Andrew: this time I was too lazy to glue the horns with the hide glue stuff and used some of the expensive epoxy instead (-S
--- End quote ---
How did you prepare the surface for epoxy, and what epoxy did you use?
simk:
thanx del 🙃
sleek: i do groove both sides well with a metal saw blade, brush them clean and glue with uhu 300 plus. but there sure are equivalent glues on the market i think. this one just has good reputation around here, is easy to work and can deal withe higher temperatures needed for heat corrections, manual says you can temper it @ 180 degree celsius👍
bownarra:
Sleek EA40 works perfectly as well. Mix it 2:1 and you have the required resistance to heat. Flat surfaces are fine, sanded to anywhere between 120 and 60 grit.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version