Main Discussion Area > Flintknapping
2021 PITH
YosemiteBen:
looking good Bj - good luck.
paulc:
Finally have my stuff boxed up and will ship out either tonight on my way home from work or over the weekend.
And pics of the points that Steve sent me...the one will be going on the end of a shaft if I can get a shaft to fly true :-)
Paul
ssrhythm:
I reveived two sweet pieces from Ben. Unfortunately the tip was broken on the dacite point and some flakes had been chipped off the obsidian biface during the rough ride in the postal carriers' vehicles. I was able to superglue the tip back on to the dacite point, and you can't tell it was ever broken. The obsidian biface wasn't affected significantly at all. I'll try to post pics tonight, but I'm currently up to my eyeballs in multiple projects pulling me in far too many directions.
bjrogg:
Well I’m sure I could spend another couple hours on this one and make it nicer, worse or completely ruin it. Guess I don’t have the time to find out and it doesn’t look just to bad. I will try to get it sent out early next week Ben.
Bjrogg
PS any suggestions for what to sign black obsidian with.
YosemiteBen:
BJ I have used a glass etcher or a diamond tip etcher.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version