Main Discussion Area > Bows
Bow string material
Muskyman:
So far my nocks kinda stink. One a fuzz higher or lower then the other.
Angle a little off from the other, etc,etc also never been really sure about the angle. I could probably make them a little steeper.
Thanks for the comments about string material. I’ll probably place an order in the next few days
richgibula:
What material is D97?
Muskyman:
BCY DynaFLIGHT 97 Bow String material
The original high strength Dyneema (100% SK75 Dyneema
Pulled right off the internet
richgibula:
Thanks for that. Do think polyester is better than UHMW polyethylene (spectra)?
Pappy:
I cut my knocks at about a 45 to start and then feather them out at the belly side as need to make the string lay smooth, I usually do over lays but not really needed for D97 if it is on some hard wood, softer wood like yew or cedar and such I would recommend overlays, I do over lays just because i like the look of them mostly. :)
Pappy
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version