Main Discussion Area > Bows

AVCase design Arvin bow build

(1/15) > >>

Selfbowman:
Ok guys Alan was nice enough to give me a design to build by and I was fortunate to have a real clean. Flat Osage stave. The design was close to my caul I normally use. The growth rings I don’t consider ideal but good and even in thickness. So. We will see how this turns out and how good I am at following the engineers drawings.🤠🤠

Selfbowman:
Y’all have seen enough of my bow builds to get this up to speed. I’ve roughed the stave out and did my first heat bend and straightening.i have the back close to width. I am marking my thickness edge to desired thickness by Alan . I will get this close and reheat the limbs to the caul. I want to hit his profiles Ass close as Arvin can do.

Selfbowman:
This is my thickness marks on the edge.

Selfbowman:
Now to connect the dots and take off the excess.

Selfbowman:
Pic

Navigation

[0] Message Index

[#] Next page

Go to full version