Main Discussion Area > Bows

What to do when your backing gets wet......

(1/6) > >>

Marin:
Hey guys,
It's been about a week since I put my last layer of sinew onto this bow, and since it had long since hardened, I thought it was best to try and put it out in the sun and wind today for a couple hours. I unfortunately did not realize that someone at my house was going to turn on the sprinklers. I grabbed the bow about 10 mins after the sprinklers turned on, and although the bow was on a rock that was not directly in the path of hte sprinklers, it still had gotten wet. I felt the back was quite sticky and brought it inside promptly and dried it. The bow still had its reflex and it did not appear that the sinew was peeling off. I have had to soak the sinew off of a bow before so I know it takes quite a bit of immersion for sinew to come off, and when it does begin to come loose one of the first signs is a relaxing of the bow's reflex.
I let it fully dry and within minutes it was mostly hard and after about an hour or so it was back to normal, though the sealing layer of glue was now a bit more rough. I assume that it was this that had taken most of the moisture and not the sinew.
I was thinking about sanding it really quick with some 220 sandpaper and covering it with another glue sealing layer, but I just wanted to know if you guys think that there are any other precautions I should take with this bow? Have I compromised it?
 I was intending on giving it at least 2-3 weeks to dry (I mean the TBB I advises as little as 10 days in dry climates, and I am in a desert state anyways). Do you think this means I should wait longer, or is the fact the sinew was probably unaffected not affect this either? I can wait longer, but I do have a sort of personal deadline for this bow I was trying to make, and if I still could I would like to. Not worth breaking this bow however.

superdav95:
Marin.  If it were me I would give it a couple weeks in an air condition environment if you can.  Then seal it up.  Just my opinion but this would allow plenty of time to get last of the excess moisture out before sealing up.  Best of luck. 

Pat B:
What glue did you use for the sinew?

Marin:
Hide glue made from Knox gelatin

Pat B:
Yeah, I think I'd do as Dave suggested.

Navigation

[0] Message Index

[#] Next page