Main Discussion Area > Bows
Glue for splice
Muskyman:
I found this place online. Don’t know anything about site and I haven’t bought anything from them. Also I haven’t checked it out at all, just saw it and thought I’d share.
Terrible picture but it says 1 pint ea-40 kit for 39.99
The complete sculptor
https://shop.sculpt.com/ea-40-transparent-laminating-epoxy-adhesive.html
Here’s the link
Much better than $75.00
bassman211:
Good heads up. Thanks. I will order a pint kit . I will pay 40 bucks for it, but not 75 just out of principle. Price gouging. A lot of that going on at present.
bassman211:
I have some nice clean Osage billets, and the cost of the glue is what has been keeping me from using them up to build bows. I have used a simple 5 inch V splice with a nylon wrapped riser that has worked for me in the past with bamboo floor board bows.
razorbak:
Thanks guys I think I’ll order some I have heard of others using different epoxy’s but I don’t know which ones was used
willie:
https://shop.smooth-on.com/ea-40
factory webstore $34.76
fresh
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version