Main Discussion Area > Bows
Show me your caul…… please
bentstick54:
Here’s one I use. I have a straight 2x2 screwed to a 2x12 on 1 side, and a radiused 2x screwed to the other side. I can clamped down and sideways at the same time when needed.
Bob Barnes:
This is an adjustable caul that will make just about any length you want.
Selfbowman:
I did these recurves with dry heat.
razorbak:
Those are great looking forms I’m gonna be incorporating some ideas in my next caul/form build I used steam today on putting some curves on a bow and damn tip overlays and underlay popped off but luckily I was able to glue it back up and once it cures I’ll try again
superdav95:
Ya I’d put any tip overlays on after any heat or steam correction fyi for future. Especially if it gets close to the outer limb and tip area.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version