Main Discussion Area > At the Forge

Mild steel trade points?

(1/2) > >>

WhistlingBadger:
Morning!  I've been looking at using trade points on a new set of hunting arrows.  Most of the ones I can find are "mild steel," which I understand is low-carbon, easy to work but not very durable.  Are these sufficient for hunting?  Is there a realistic way to harden them?  I keep reading about putting them in a container with some charcoal and throwing them in the campfire coals for several hours...

mmattockx:
If it's mild steel there simply isn't enough carbon to be able to significantly harden them. Putting them in a container with charcoal at temperature may carburize them a bit, but I wouldn't count on it. More than how durable they will be I would be concerned with putting a decent edge on them. I've never been able to get any non-hardened steel up to something I would call truly sharp.

Maybe others have had better experiences with them?


Mark

Pat B:
I had a blacksmith friend try to add carbon to a piece of mild steel I was going to make a knife with. He even use carbon that is used fir it but it wasn't successful. If there are shipping or freight companies near you banding steel they use will work good and you can cut it with shears or a cold chisel then hammer it flat and sharpen it. It will hold an edge.

WhistlingBadger:
Interesting!  Thanks for the insights.

KHalverson:
7-1/4 inch circular saw blades without carbide tips are a great source of steel to make trade points..
most ive delt with will sharpen nicely.

Navigation

[0] Message Index

[#] Next page