Main Discussion Area > Bows
Question on tillering a snake bow?
Eric Krewson:
I have used a long snaky stave, cut it in half and re-orientate the limbs to line them up and take most of the twist out by the way I spliced the billets back together
Bob Barnes:
--- Quote from: Selfbowman on November 05, 2025, 12:12:30 am ---Nonbacked that’s exactly what I’m talking about. I done it on a couple bows. Bob Barnes has one. Maybe he can measure the edges of the bends and shed some light on what I’m saying. Hello Bob! 🤠🤠
--- End quote ---
That's a nice stave Arvin. Let me know what you need as far as measurements or pictures. I typically try to maintain a uniform belly, but I do make it slightly rounded like Eric does. The idea that you are exploring sounds like it might work on some squiggles, but my last one had a place or two that you couldn't make a "T" to follow.
Selfbowman:
Ok Bob where the limb goes out past the string is the side closest the string thicker than the outside of the bend???is the section where the string is in the middle of the limb close to the same thickness all the way across. From looking at my growth ring below on the edges that’s what I see.is that your bow or the one I made you?? Regardless is the thickness like I ask question about?
Bob Barnes:
The side closest to the string is a little thicker, but it's hard to be exact since I've already slightly rounded the edges. It's about .01" thicker. The 45° bend just before the part that's off the string is where the limb rings opened up/separated.
I marked the spot where the string crosses the limbs, and they are the thicker parts. The back is almost flat.
bentstick54:
Arvin, I don’t know if this will help or not, but here is one I made. It shots fine with little hand shock, but it does twist a little in the hand on release I contribute to so much limb protuding out from the string on the upper limb. There is just more mass weight on the right side of center than left. Limb thickness is consistent all the way with the back tip to tip.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version