Main Discussion Area > Arrows
Cane arrow help
Don:
Thanks jackcrafty, Thats what I needed. The steps ;D.
I haven't had time to do anything with these, they've been bundled for the last two weeks.
And I hope they will still be able to be straightened after another few weeks.
We've been working the floods here in Iowa none stop and I haven't had time for this.
Thanks for everyone help. :) Don
billy:
HEy Don,
That stuff is NOT rivercane. It is bamboo. The bamboo I have seen usually has a much more dramatic taper than the rivercane I use. But don't worry. It will most likely work for arrows. The only thing that matters is how well it shoots off your bow. If it flies perfectly, then that's all that matters. I would reduce the nodes somewhat, but not too much. If you scrape the nodes so their diameter is even with the bamboo on either side of it, the strength will be seriously compromised and they will break there if they hit a glancing blow.
Don:
Thanks Billy.
I've set them to the side for now, trying some Lowe's Boo, which work good.
This Miss. stuff has some really big nodes and where there should be leaves there is limbs. I'll keep messing with it though.
Thank again. Don
mullet:
It's not cane, Hillbilly nailed it the first time. It makes good arrows but I've found it works best if you pull it down and cut the tops out. It doesn't start flat sideing as quick up there. And you can grind the bejeezes out of those nodes.
Hillbilly:
--- Quote ---I would reduce the nodes somewhat, but not too much. If you scrape the nodes so their diameter is even with the bamboo on either side of it, the strength will be seriously compromised and they will break there if they hit a glancing blow.
--- End quote ---
I've never found this to be true at all. I've made hundreds of cane arrows, and I always take the nodes down even. I don't want bumps sticking out to hit the bow. I've so far never broken a cane arrow shooting it after shooting them by the thousands, and that's saying something as I'm a horrible shot and seem to have a gift for dead centering (and glancing blows) off rocks, trees, and suchlike. I've seen examples of bowstrings made from split cane in which the nodes were smoothed down even, and if it was that weak, it sure wouldn't last as a bowstring. The only time I break cane at the nodes is occasionally by overheating and bending too fast while straightening them. I do the major straightening before smoothing the nodes as they are a weak spot when you heat them. Otherwise, I've never had any trouble, and I can sure break me some wooden arrows in a hurry. The weakest point on a cane arrows is still ten times stronger than the best commercial POC shaft. :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version